DIY SmartBlinds v3 is based on a Nema 14 stepper motor and 12v power supply.
iMac 2013 Headset Mount
When working from home maybe its time to organise and cleanup your desk. To start, I designed this headset mount / hook that attaches to your iMac’s left hand side of the screen. It attaches with some double sided tape and is not obtrusive. Printed on: Prusa i3 MK3 Filament used: 3D Fillies PLA+ Silver …
Amazon Echo Dot 3 Wall Mount
Its not always convenient to place the Echo Dot on a flat surface. A wall mount is sometimes more suitable and practical. You can obviously just use double sided tape and attach it to the wall but why do it if you can 3D print your own mount. I designed this to be minimalistic and …
Aqara Temperature Sensor Wall Mount
This is a quick and very simple 3D design for a mount for your Aqara Temperature Sensor. This mount has a usual hole at the back for wall mounting and the sensor just snaps into place.
The Letterbox Tray
Our letterboxes are located outside, ours is on the bottom of the stack. Every time it rains or the sprinklers are on, the water runs down the walls, into our letterbox and settles on the bottom. This makes for very wet letters. Enough is enough. You can’t fight the weather or the strata management, so …
Curtain Rod Holders
This is a very simple design since the original holders are no longer available at my local hardware store. It was much easier to design and print these than source new ones 😉 These holders can fit a rod of 19mm in diameter. I printed these on my Prusa i3 MK3 printer with 0.2 layer …